Normal Operation - Takagi T-H2-DV Installation Manual And Owner's Manual

NORMAL OPERATION

1. Open a hot water tap.
x Flow rate to activate the T H2 DV/T H2 OS
x Flow rate to keep the T H2 DV/T H2 OS running : 0.4 gallon per minute
H
ot Water temperatures over 125qF can cause severe burns instantly
or death from scalding.
x The outlet hot water temperature of the T H2 DV/T H2 OS water
heater is factory set at 120qF.
x Feel the water temperature before bathing or showering.
On T H2 DV/T H2 OS, changing the temperature setting can be done simply by using the 3 digit 7 seg.
LED, and the "Increase" & "Decrease" buttons on the computer board (TM RE30 remote controller is not
required)
T H2 DV/T H2 OS
GENERAL
2. Mix cold water with the hot to get
the correct temperature water.
WARNING
WARNING
TEMPERATURE SETTINGS
ON THE T H2 DV/T H2 OS
x The T H2 DV/T H2 OS will display the set temperature on the 3 digit 7
Seg. LED on the computer board. This LED is visible through a small
window on the unit's front cover.
x If the TM RE30 is installed, refer to the TM RE30 Installation Manual
included with the remote for setting temperature.
37
3. Close the hot water tap.
: 0.5 gallon per minute
Page
Normal Operation