Belt Tracking Adjustment - LifeSpan Equilizer XL User Manual

4.7 Belt Tracking Adjustment:

This treadmill is designed to keep the belt reasonably centred while in use. It is normally
for some belts to drift near one side while the belt is running with no one on it. After a
few minutes of use, the belt should have a tendency to centre itself. If during use, the
belt continues to move toward one side, adjustments are necessary. The procedures are
as below:
▲ First set speed at approximately 3.5km/h.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using
6mm Allen Key, until the belt is centered itself; If belt shifts to left, tighten the left bolt
and loosen the right bolt by using 6mm Allen Key, until the belt is centered. When
adjusting the belt using the 6 mm Allen Key, it is important to adjust the belt in half turn
increments. Over adjusting will cause damage to the mat.
If the belts has drifted to the RIGHT If the belts has drifted to the LEFT
LIFESPAN EQUALIZER XL Page 17