Repeater - Icom IC-41S Instruction Manual

6
SCAN
■

Repeater

The repeater search scan is not only used to search for a sig-
nal on the repeater channels, but also to access a repeater by
transmitting automatically in sequence. The repeater search
function searches available repeaters in the area .The re-
peater scan detects signals on repeater channels. When the
repeater is not busy, it will be available for use. The repeater
scan will stop should any activity be detected (The scan is
cancelled when receiving a signal, such as stations commu-
nicating in simplex operation on a repeater output channel).
• Excludes emergency repeater channel CB-R5.
To start the repeater scan:
q
Select the desired repeater output channel and push and
hold for 2 seconds to start the repeater scan.
w When a signal is received on the repeater channel, scan-
ning will stop. (during the second cycle scanning the re-
peater channels, three high beeps will sound when a sig-
nal is received, and three low beeps will sound when no
signal is received)
e
Push to cancel the scan manually. (when transmitting,
the repeater scan cannot be cancelled)
20
D
Repeater search scan fl ow
Scan start
channel
Appears
Blinks
Appears
Scan is cancelled automatically.
NOTE: Excludes Emergency Repeater 'CB-R5.'
Searches for sig-
Scan nal on the repeater
output channels.
Access to the repeater
automatically. (0.5 sec.)
Wait for a signal from
the repeater. (0.5 sec.)
(When not reply signal is received.)
Access to the next
repeater automatically.
Scan