D Beep; D Beep Level; D Mic Gain; D Battery Voltage - Icom IC-41S Instruction Manual

D
Beep
By default, confi rmation beep tones are turned on. This can
be toggled ON or OFF by the set mode, for silent operation.
Beep tone ON (default)

D Beep Level

The volume level of the key touch beep can be altered from 1
(softest) to 5 (loudest).
Beep level 3 (default)
D
Mic Gain
The sensitivity of the microphone can be changed from 1
(minimum sensitivity) to 5 (maximum sensitivity). With a
higher sensitivity, the microphone will register softer voices,
although, it may pick up more ambient noise.
Mic gain level 3 (default)
D
Battery Voltage
The transceiver can be set to display the remaining battery
charge for a 2 second period after being turned ON.
Beep tone OFF
D
Signal Monitor
This function controls the mute condition during selcall code
signal and roger beep emission. By default, it is turned ON.
Signal monitor ON (default)
Beep level 1

D Power Save

The auto power save function works by deactivating the re-
ceiver circuit, which reduces battery consumption. If a signal
is not received, or the unit is inactive for 5 seconds, the trans-
ceiver will enter power save mode.
Power save ON (default)
Mic gain level 1
Battery voltage
OFF (default)
4
SET MODE
4
Battery voltage ON
Signal monitor OFF
Power save OFF
13