Data Mode With Filter Width Settings; Repeater Tone/Tone Squelch Frequency; Settings; Dtcs Code And Polarity Setting - Icom IC-905 Reference Manual

REMOTE CONTROL
Remote control (CI-V) information
D Command formats

• Data mode with filter width settings

Command: 1A 06
1 2
X X X X
00=Data mode OFF* 01=FIL1
01=Data mode ON 02=FIL2
03=FIL3
*
When 00 is set, also set 00 to 2.
• Repeater tone/tone squelch frequency settings
Command: 1B 00, 1B 01
1* 2
0 0 X X
*Not necessary when setting a frequency.

• DTCS code and polarity setting

Command: 1B 02
1 2
X X 0 X
Receive polarity: 0=Normal
Transmit polarity: 0=Normal

• DV Digital code squelch setting

Command: 1B 07
1
X X
3
X X
3
X X
1=Reverse
1=Reverse

• DV MY call sign setting

Command: 1F 00
Set your own call sign and note of up to 12 characters�
See "Character's code of the call sign�"
1 ~ 8
X X X X X X X X X X X X
∙∙∙∙∙∙∙∙
1 ~ 8: Your own call sign setting (8 characters)
9 ~ 12: Note setting (4 characters)

• DV TX call signs setting

(24 characters or 8 characters)

Command: 1F 01
Set "UR," "R1," and "R2" call signs of 8 characters
(fixed), or only the "UR" call sign�
See "Character's code of the call sign�"
When setting "UR," "R1," and "R2" call signs
1 ~ 8
X X X X X X
∙∙∙∙∙∙∙∙
1 ~ 8: UR (Destination) call sign setting
(8 characters)
9 ~ 16: R1 (Access/Area repeater) call sign setting
(8 characters)
17 ~ 24: R2 (Link/Gateway repeater) call sign setting
(8 characters)
When setting only the "UR" call signs
1 ~ 8
X X X X
∙∙∙∙∙∙∙∙
1 ~ 8: UR (Destination) call sign setting
(8 characters)
Character's code of the call sign
Character ASCII code
0 ~ 9 30 ~ 39
A ~ Z 41 ~ 5A
(Space)
/

• DV TX message setting

Command: 1F 02
Set the transmit message of up to 20 characters�
See "Codes for character entries�" (p� 19)
"FF" stops sending or reading messages�
23
9 ~ 12
9 ~ 16 17 ~ 24
X X X X X X
∙∙∙∙∙∙∙∙ ∙∙∙∙∙∙∙∙
20
2F