Dynacord DMM 4650 Owner's Manual page 41

Sequence Nummer
S 30
Step Command Parameter
1: Out C3 set
2: Record m 02
3: Out C2 set
4: Dly= 010,05
5: if stop
6: Nop
7: if Stop
8: Jump
9: if Delay
10: Jump
ll: if Audio
12: End
13: Jump
14: Finish
15: Out 2 cir
16: Jump
Sequence Nummer
S 31
Step Command Parameter
1: Out Al set
2: wt Al High
3: Out B4 car
4: Out B2 set
5: Out
6: out
7: DMM=
8: Sum=
9: Start A 20
10: wt In D2 High
ll: Break
12: Sum= 0 dB
13: wt In D2 Low
14: Jump
15: End
Title
"EasyRec2"
Starts the recording of Message 02 (remote recording),
starts by briefly pressing the input C4 button (menu trigger),
stops by pressing the input C4 again
Description: Closing the signaling contact (C3 = remote recording
runs) starts erasing the message. After successful erasing the
signal contact C2 (=start recording) is being closed. The recor-
ding is terminated by switching the control input C4 (current input
C4 on). If the termination of the recording mode is not recognized,
14 the maximum duration is limited to 1 0 sec. Name and priority of
the message stay unaltered and the DMM 4650 re-enters the
14 stand-by mode.
07
11
Title
"Fire-Mic"
B3
A3
-5(
off
07
Priority
80
Priority
98
Starts a continuous DIN-alarm, pressing the key "fire micro-
phone" allows for an announcement via audio input, after
the key is being released the alarm is continued.
Description: Turns the power of the electro-acoustics sound
reinforcement system on (relay Al) and waits for acknow-
ledgment (input Al = system ready). When the system is ready,
the output B4 (music program off) is opened and B2, B3 (man-
datory reception E, D) gets closed. Closing the signaling contact
(A3 = alarm signal running) switches the audio controls to priority
for the alarm signal. The alarm signal (A20) is being outputted
and runs continuously until the alarm is interrupted by a high
signal (=current) at the control input D2 (=fire announcement).
As long as the high potential is present at D2, priority is given to
the audio input. The alarm continues (infinitely) as long as the D2
potential is low.
A sequence with a higher priority (e. g. S 20) stops this sequence.
The control over settings and relay contacts is taken over by the
stop sequence. After the stop sequence ends the DMM 4650
returns to the stand-by mode.
41
Stopp trigger
C4 High >00,1s tat
Stop trigger
off