Dynacord DMM 4650 Owner's Manual page 38

Sequence Nummer
S 23
Step Command Parameter
1: Out A1 Set
2: wt In A1 High
3: Out B4 clr
4: Out B2 set
5: Out B3 set
6: Out A3 set
7: Sum=
8: DMM= -5dB
9: Start A20
10: wt Stop
11: End
Sequencee Nummer
S 24
Stop Command Parameter
1: Out A1 set
2: wt In A1 high
3: Out B4 Clr
4: Out B2 set
5: Out B3 set
6: Out A3 set
7: Out A2 set
8: SUM=
9: DMM= -5 dB
10: Stert A 34
11: wt Audio
12: Dly= 001,0s
13: wt Delay
14: DMM= -2 dB
15: Start m 00
16: wt Audio
17: Dly= 001,0s
18: wt Delay
19: if Stop
20: End
21: Jump
22: End
Title
"DIN-Airm"
Start DIN alarm (key E31 ON), Stop with key Bl OFF
Description: Turns the sound reinforcement system on (relay Al)
and waits for acknowledgment (input Al = system ready). When
the system is ready, the output B4 (music program off) is opent B2 set
and B2, B3 (mandatory reception E, D) gets closed. After closing
the signaling contact (A3 = alarm signal running) the audio
controls are set to alarm text priority. The output of the alarm
off signal (A20) is started. This sequence is terminated when the
input Bl is Low (no current). Upon completion, the DMM 4650
returns to stand-by mode.
Title
"Airm-Txt"
DIN alarm > alarm text > DIN alarm sequence, (start key B2
ON), Stop with key B2 OFF
Description: Turns the sound reinforcement system on (relay Al)
and waits for acknowledgment (input Al = system ready). When
B2 set the system is ready, the output B4 (music program off) is being
opened and B2, B3 (mandatory reception E, D) gets closed. After
closing the signa@ing contacts (A3 = alarm signal, A2 = alarm text)
off the audio controls are set to alarm priority. The output in se-
quence is: alarm signal 5 sec (A34) 1 sec. pause alarm text
(MOO) 1 sec. pause alarm signal 5 sec. (A34) 1 sec. pause, etc.
A 34 until the input B2 = Low (no current) terminates the sequence.
Upon termination the DMM 4650 returns to stand-by mode.
09
Priority
95
Priority
91
38
Stopp trigger
Bl Low> 00,1 stc
Stopp trigger
B2 Low > 00, 1 s Stc