Factory Presets; Factory Presets, Defaults; List Of Trigger Signals - Dynacord DMM 4650 Owner's Manual

The installed software v 1.2 provides pre-stored factory presets for sequences, alarms and gongs. Also defined are
basic settings (menu "System setup") as well as input and output lines. For direct use of these presets, installation
examples are to be found on page 31.
Factory settings, defaults
The user can edit these defaults according to individual requirements.
The data of the menus "outputs" "standby" and "sum level" determines the status of the DMM 4650 in stand-by mode
(no sequence running). A running sequence could lead to a modification of the outputs. Upon completion of the
sequence, the outputs are switched back to their previous status (stand-by mode).
Menu Parameter 1
Contrast 0%
Backlight 50%
Phones 75%
Priority Prio1 33
Password Priol 1111
Outputs all Low (relay open), except B4 = High
Bypass off (relay open)
Sum Gain OdB
Attenuation alarms OdB
Language German
RS 232 9600 Baud

List of trigger signals

Delay Trigger starts
Input Level
sec. type
Al Off
A2 high >00, 1 dyn
A3 high >00, 1 dyn
A4 high >00, 1 dyn
Bl high >00, 1 dyn
B2 high >00, 1 dyn
B3 high >00,1 dyn
B4 high >00, 1 dyn
Cl high >00, 1 dyn
C2 high >00,1 dyn
C3 high >00,1 dyn
C4 high >00, 1 dyn
Dl high >00,1 dyn
D2 Off
D3 high >00, 1 dyn
D4 high :>00, 1 dyn

FACTORY PRESETS

Parameter 2
Prio2 66
Prio2 2222
gongs OdB
sequence
release, S21 to S25, S31 and S33 to S37 wait for High at At, return messag(
for system ready, upon release the signal output starts
S20 stops each running sequence
S21 start alarm message MOO
S22 start DIN alarm, pulse trigger
S23 start DIN alarm, high = start, low = stop,
S24 start alarm text sequence, high = start, low = stop,
S25 4-tone gong, pulse trigger
S26 Pre-gong (2-tone), pulse trigger
S27 start message M01, pulse trigger
S28 start message M02, pulse trigger
S29 remote recording M01, pulse trigger, first pulse = start, second pulse = stop
S30 remote recording M02, pulse trigger, first pulse = start, second pulse = stop
-S31 start DIN alarm with announcement key at D2, pulse trigger
announcement in S31, high = announcement, low = alarm
S32 start announcement DMM 4650 Mic, high = start, low = stop-
S36 Morse key
Parameter 3
Prio3 99
Prio3 3333
messages OdB announcements OdB-
utilization
Function (see sequence)
36
Parameter 4