Gong; General; Gong Presets; Operation Menu Gong - Dynacord DMM 4650 Owner's Manual

GONG

General

:
Gong Presets are audio signals that can be started within a sequence. Order and parameters of a gong sequence can
be edited. For test purposes the sound can be started in the "gong > editor" menu by use of the PLAY/STOP keys. it
is audible via the Pre-Listen outputs.

Gong Presets

20 freely programmable presets (user preset) are available; from GOO - G19. Starting with G20 and going to G26
factory preset gong sequences are programmed. The corresponding functions are explained in the table on page 45.
Erasing the factory presets is not possible. Creating your own gong sequence is easiest accomplished by modifying
an existing, possibly similar gong (user or factory preset) and storing it under a new number together with its new title
and priority.

Operation menu gong

Confirming the menu selection "gong" with the soft key "ok", the cursor keys < > allow selecting the following sub
menus.

Load

Confirming "load" with the soft key "ok", "Gxx 'Title 'and the soft keys 'yes, no" appear on the display. Using the cursor
keys the gong number xx is modified while the corresponding name is being displayed. "y" lets you load the selected
gong into memory and modification is performed in the "editor" menu.
Editor
The "editor" menu allows modification of gong sequences, envelopes, repetition amounts and several other para-
meters (see parameter listing). Testing the gong's sound properties is possible by starling the gong sequence, using
the PLAY/STOP key. The audio signal is presented at the pre-listen outputs. Parameter modifications are audible
after performing a restart. Pressing the RECORD key stops the gong. After pressing the "EXIT"key (previous menu
level), the question 'store yes, no?"appears on the display. Acknowledging this question lets you save your new
settings in a user preset.

Title

Confirming "Title"with the soft key "ok", the name of the currently loaded gong sequence appears on the display.
Using the cursor keys you are able to enter a new name that consists of up to 8 characters. The soft keys "A-a" are
used to shift between the upper and the lower character case while "spc" inserts a blank character. After pressing the
"EXIT"key (previous menu level), the question "storeyes, no?"appears on the display. Acknowledging this question
lets you save your new settings in a user preset.

Priority

Confirming "Priority"with the soft key "ok", the priority number of the selected gong preset gets displayed. Using the
cursor keys, the priority number can be set starting from 00 up to the user priority. A higher priority protects against
unauthorized alteration of this preset by users with lower priority level. All factory presets are provided with a priority
of 00, because they cannot be overwritten, anyway. This offers any user the possibility to use them as prototype
sequences.
After pressing the "EXIT'key (one menu level down), the question 'store yes, no?"appears on the display. Acknowledging
this question lets you save your new settings in a user preset.

Save

Confirming "save" with the soft key "ok", the currently selected gong number gets displayed. Using the cursor keys,
the desired gong number can be entered. Storing a preset has to be confirmed with the soft key "y =yes". With
"save'all modifications in the above mentioned menu items are saved into the selected user preset. Thus, individually
saving the parameters is not necessary, since they remain in memory until another gong is being loaded.
15