Dynacord DMM 4650 Owner's Manual page 39

Sequence Nummer
S 25
Step Command Parameter
1: Out Al set
2: vvt In Al High
3: Out B4 clr
4: Out B2 set
5: Out B3 set
6: Out A4 set
7: Sum=
8: DMM= -5dB
9: Start G 20
10: wt Audio
ll: End
Sequence Nummer
S 26
Step Command Parameter
1: Out B4 cir
2: Out B2 set
3: Out Bl set
4: Sum= -3dB
5: DMM= -5dB
6: Start G 24
7: Diy= 004,0 s
8: wt Deiay
9: Out Bl cir
10: wt Audio
ll: wt Stop
12. End
Sequence Nummer
S 27
Step Cmmand Parameter
1: Out Cl set
2: Sum=
3: DMM= -2dB
4: Start M 01
5: wt Audio
6: End
Title
"Vierking"
4-tone gong
Description: Turns the sound reinforcement system on (relay Al)
and waits for acknowledgment (input Al = system ready). When
the system is ready, the output B4 (music program off) is being
opened and B2, B3 (mandatory reception E, D) gets closed. After
closing the signaling contact (A4 = gong runs) the audio controls
are set to gong priority. The gong signal is being output and
off fades. After the fade-out the DMM 4650 returns to stand-by
mode.
Title
"Vorgong"
Start Pre-gong (key B4 on), end of announcement with key B4 off
Description: The output B4 (music program off) is opened and in
succession B2 (mandatory reception E) is being closed. After
closing the signaling contact (Bl = pre-gong runs) the audio
controls are set to audio input/pre-gong mix. After 4 seconds the
signaling contact (B1, ready for announcement) is being opened.
The audio controls remain unchanged until control input B4
terminates the sequence. Afterwards, the DMM 4650 re-enters
the stand-by mode.
Title
"Message l
Start Message 1
Description: After closing the signaling contact (Cl = message
off runs) the audio controls are set to prioritize this message. After
the message is finished the DMM 4650 re-enters the stand-by
mode.
Priority
89
Priority
87
Priority
80
39
Stopp trigger
off
Stopp trigger
B4 Low >00, 1 s stc
Stopp trigger
off