Self-Test; General; Operation Menu Self-Test - Dynacord DMM 4650 Owner's Manual

Self test

General

In stand-by mode the DMM 4650 runs a number of test routines in order to detect device faults at an early stage.
Errors are indicated by the flashing of the green POWER LED. On fatal errors or on a higher occurence of errors, the
flashing gets faster and the fault relay drops. At the same time the audio input is connected directly to the output via
the bypass relay. This menu allows to locate the cause for a device break-down.
Operation menu self test
Confirming the menu selection "self test" with the soft key "ok" displays an error number ("Er#xx"), the amount and a
scrolling text in the lower line on the display. Using the cursor keys lets you select individual error numbers. The
actual meaning of these numbers is explained in the table on page 47. The number shows how often a specific error
has occurred. The scrolling text records the first and last occurence of the error (see "setting clock"). The EXIT key
terminates this menu (return to the prior menu level).
Note: Error no. 1 only counts the switching "on" and "off' of the DMM 4650, but does not lead to an external error
display (Power On Reset).
In case that error no.14 leads to the blinking of the green POWER LED, the data of one or more messages has been
corrupted. The corresponding message(s) is(are) marked with an asterisk (*) (see also page 14).
29