Configuring The Serial Ports; Mode; Figure 7-5. Setup Serial Port 1 Screen - Eaton Powerware 9315 Operation Manual

7.4 Configuring the Serial Ports

You must configure the port for communication using the LCD screen and buttons on the
UPS Monitor Panel.
Select Port 1 from the Setup menu to display one of the Setup Port screens. The screens
for Port 1 and Port 2 are identical, and allow you to specify settings for the two serial
communication ports. Figure 7-5 shows the Setup Serial Port 1 screen.
UPS System Normal
Alarm:
Notice: None
Meters
A small return arrow (
arrow is a reminder that you can press the
buttons between the menu box and the information area.
If the scroll bar is in the menu box, press the
area. The first setting (Mode) is highlighted. Press the
to the setting you want to change. To scroll through the available options for that setting,
press the
To save the settings upon exit from this screen, be sure the Save field is set to YES.
9315 UPS (300–500 kVA) Operation Manual S 164201119 Rev F www.powerware.com
EATON Powerware
®
NOTE You should only configure Port 1 unless field service has performed a wiring
change for Port 2.
None
Battery
Percent
100%
Setup
Port 1
Port 2
Time
Events Statistics Graphics

Figure 7-5. Setup Serial Port 1 Screen

or button.
Uninterruptible Power System
Setup Serial Port 1

Mode

Rate Data/Stop
TERMINAL 9600 8
Setup
) appears in the upper right corner of the Setup Port screen. This
button on the Monitor Panel to toggle the
Serial Communication
03 NOV 1997 14:23:45
Handshaking Save
1 XON / XOFF NO
button to toggle to the information
or button to move the highlight
7−5