Configuring The Modem To Call A Numeric - Eaton Powerware 9315 Operation Manual

Remote Notificaton
6. Confirm that the modem responds with OK" or 0" (zero).
7. Key in [A], [T], [&], [W], [0] (zero), then press [ENTER].
8. Confirm that the modem responds with OK" or 0" (zero).
9. Key in [A], [T], [&], [Y], [0] (zero), then press [ENTER].
10. Confirm that the modem responds with OK" or 0" (zero).
11. Connect a telephone line to the modem and test the modem by keying in [A], [T],
12. The modem dials the telephone number stored in Step 4 or 5. (The number is
13. Confirm that the modem responds with 1" (one) when the connection is made.
NOTE To set up a group one or group two pager number, continue to the following
section, Configuring the Modem to Call a Numeric Pager."
8.4.3 Configuring the Modem to Call a Numeric Pager
To configure the modem to call a numeric pager system, perform the following procedure.
NOTE The brackets ([ ]) in the following steps indicate characters that require keying in
prior to pressing [ENTER].
1. Connect the modem to the PC through the serial port as described in the modem
2. Key in [A], [T], then press [ENTER].
3. Confirm that the modem responds with OK" or 0" (zero).
8−6
EATON Powerware
[D], [S], [0] (zero), then pressing [ENTER].
displayed on the terminal screen as it is dialed.) Repeat Steps 4 (or 5) through 11
as necessary to modify the telephone number.
manufacturer's manual.
9315 UPS (300–500 kVA) Operation Manual S 164201119 Rev F www.powerware.com
®