Configuring The Serial Ports; Figure 12-3. Setup Serial Port 1 Screen - Eaton POWERWARE 9315 Installation And Operation Manual

12.3

Configuring the Serial Ports

EATON Powerware
Configure the communication port using the LCD screen and pushbuttons on the UPS
control panel.
Select Port 1 or Port 2 from the Setup menu to display one of the Setup Port screens.
The screens for Port 1 and Port 2 are identical, and allow you to specify settings for
the two serial communication ports. Figure 12-3 shows the Setup Serial Port 1
screen.
UPS System Normal
ALARM: NONE
NOTICES: NONE
Battery
Percent
100%
Setup
Port 1
Port 2
Time
Meters Events Statistics Graphics
A small return arrow (
This arrow is a reminder that you can press the
to toggle the pushbuttons between the menu box and the information area.
If the scroll bar is in the menu box, press the
information area. The first setting (Mode) is highlighted. Press the
to move the highlight to the setting you want to change. To scroll through the
available options for that setting, press the
To save the settings upon exit from this screen, be sure the Save field is set to YES.
Table 12-3 shows which options are available for each port. The sections that follow
describe the configuration settings you can change.
®
9315 UPS (500–750 kVA) Installation and Operation Manual
Uninterruptible Power System
Setup Serial Port 1
Mode Rate Data/Stop
TERMINAL 9600 8
Setup

Figure 12-3. Setup Serial Port 1 Screen

) appears in the upper right corner of the Setup Port screen.
pushbutton to toggle to the
or
S
164201691 Rev 1 www.powerware.com
COMMUNICATION
15 JUL 1998 09:25:42
Handshaking Save
1 XON / XOFF NO
pushbutton on the control panel
or pushbutton
pushbutton.
12-3