Configuring The Modem To Answer Incoming Calls - Eaton Powerware 9315 Operation Manual

Remote Notificaton

8.4.4 Configuring the Modem to Answer Incoming Calls

To configure the modem to answer incoming calls, perform the following procedure.
NOTE Calling into the UPS does not present any type of security risk. There are no
commands that can be executed via the call-in feature except those available to the
Terminal mode.
1. Connect the modem to the PC through the serial port as described in the modem
NOTE The brackets ([ ]) in the following steps indicate characters that require keying in
prior to pressing [ENTER].
2. Key in [A], [T], then press [ENTER].
3. Confirm that the modem responds with OK" or 0" (zero).
4. Key in [A], [T], [S], [0] (zero), [=], [2], then press [ENTER].
5. Confirm that the modem responds with OK" or 0" (zero).
6. Key in [A], [T], [S], [0] (zero), [?], then press [ENTER].
7. Confirm that the modem responds with OK" or 0" (zero) and a value of 002".
8. Connect a telephone line to the modem. Test the modem by using another PC
9. Confirm that the UPS modem responds with 2" when the phone is ringing, and a
10. Key in [A], [T], [&], [W], [0] (zero), then press [ENTER].
11. Confirm that the modem responds with OK" or 0" (zero).
12. Key in [A], [T], [&], [Y], [0] (zero), then press [ENTER].
13. Confirm that the modem responds with OK" or 0" (zero).
8−8
EATON Powerware
manufacturer's manual.
equipped with a modem to dial the first modem.
1" after the UPS modem has answered and the carrier has been detected.
9315 UPS (300–500 kVA) Operation Manual S 164201119 Rev F www.powerware.com
®