Connecting The Power Cords - Avaya G650 Installing

Power source options:
Single phase 120 VAC with neutral wire
●
Single phase 240 VAC with neutral wire
●
—48 VDC
●
Power input receptacles:
120 VAC, 60 Hz NEMA 5-15R to IEC 60320 appliance inlet
●
240 VAC, 50 Hz country selectable to IEC 60320 appliance inlet
●
When you install G650s in Japan, use country specific receptacles for 100 and 200 VAC,
●
50/60 Hz
When you install G650s in Mexico, use country specific receptacles for 127 VAC
●

Connecting the power cords

!
WARNING:
The AC power cord can connect to a properly rated power distribution unit,
WARNING:
individual AC power receptacles, or to an UPS. Avaya recommends a
rack-mounted UPS.
To connect the power cords:
6. Ensure that the circuit breakers at the AC load center are OFF.
7. Connect the G650 Media Gateway to a UPS or to a "nonswitched" or "always on" electrical
outlet. See
Figure 10: Grounding for multiple G650 Media Gateways
Checking AC power
Each G650 Media Gateway uses at least one auto-ranging (90 to 265 VAC) power supply:
47 to 63 hertz
●
500 watts output
●
7.2 amps (90 VAC) or 3.3 amps (200 VAC)
●
Figure 9: Grounding for one G650 Media Gateway
Installing the G650 Media Gateway
on page 43 and
on page 44.
Issue 1 February 2006 45