Installing The Tn2312Bp Ipsi Adapter - Avaya G650 Installing

EMI gaskets provide Electro Magnetic Interference (EMI) to or from the TDM cable with the
outside environment. You must install the EMI gaskets before putting cabinets B, C, D, or E in
the rack.
To install the EMI gaskets:
1. Peel the paper backing from the gasket
2. Locate the unpainted outlined area on top of the G650 Media Gateway
3. With the gasket opening facing the rear of the rack, place the gasket on the:
a. Right top for G650 A and C
b. Left top for G650 B and D
After you put the last G650 in the rack:
4. Cable the rack (see
5. Install the TN2312BP IPSI adapter (proceed to
page 41).

Installing the TN2312BP IPSI adapter

Install the TN2312BP IPSI adapter on the connector panel in position 1 for carrier A. If you are
using duplicated IPSIs, connect another IPSI adapter in position 1 for carrier B. Connect the
CAT 5 ethernet cable to the adapter to connect the G650 to the ethernet.
adapter shows the adapter.
If you want to use the external alarm function, attach an 9-pin external alarm cable to the
TN2312BP IPSI adapter. For the unterminated end, see the job aid titled Connector and Cable
Diagrams (Pinout Charts) (555-245-773).
Cabling the G650 Media Gateways
Installing the G650 Media Gateway
on page 53).
Installing the TN2312BP IPSI adapter
Figure 8: G650 IPSI
Issue 1 February 2006
on
41