Front I/O Assembly - HP Elite 8300 Series Convertible Minitower Maintenance And Service Manual

Front I/O Assembly

Description
Front I/O assembly
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Remove the front fan
5. Disconnect the three front I/O cables (yellow, green, and blue) from the system board
connectors (FRONT USB1, FRONT USB2, and FRONT AUD).
6. Remove the Torx T15 screw that secures the assembly to the chassis.
Figure 7-27
7. Rotate the left side of the assembly to the right .
Figure 7-28
8. Pull the assembly away from the computer while threading the wires through the hole in the front
of the chassis.
To reinstall the assembly, reverse the removal procedure.
(Front Bezel on page
(Front Fan Assembly on page
Removing the front I/O assembly screw
Removing the front I/O assembly
(Preparation for Disassembly on page
(Computer Access Panel on page
124).
147).
Spare part number
646827-001
75).
123).
Front I/O Assembly 149