Front I/O, Power Switch Assembly - HP Elite 8300 Series Convertible Minitower Maintenance And Service Manual

Front I/O, Power Switch Assembly

Description
Front I/O and power switch assembly
The front I/O and power switch/LEDs is one assembly, attached to the front of the chassis. Push the
assembly into the chassis to remove.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Remove the chassis fan
5. Rotate the drive cage to its upright position.
6. Disconnect the four cables from the system board as follows:
●
Yellow connector labeled FRONT_USB
●
Green connector labeled FRONT_USB2
●
Blue connector labeled FRONT AUD
●
Black connector labeled PB/LED
Figure 8-32
7. Remove the Torx T15 screw (1) that secures the assembly to the front of the chassis.
194 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Access Panel on page
(Front Bezel on page
(Front Fan Assembly on page
Disconnecting the front I/O, power switch/LED assembly cables
(Preparation for Disassembly on page
164).
165).
191).
Spare part number
636926-001
163).