Power Switch Assembly - HP Elite 8300 Series Convertible Minitower Maintenance And Service Manual

Power Switch Assembly

Description
Power switch/LED assembly
The power switch assembly is mounted to the front of the chassis and removed by pulling it away
from the chassis.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the computer access panel
4. Disconnect the cable from the black system board connector labeled PB/LED.
5. Press downward on the tabs (1) at the top of the assembly.
6. Rotate the top of the assembly downward (2), and then pull it away from the chassis while
threading the wires through the hole in the front of the chassis.
Figure 6-31
To install the power switch assembly, reverse the removal procedure.
Removing the power switch assembly
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page 77).
Spare part number
646820-001
75).
76).
Power Switch Assembly 107