Hood Sensor - HP Elite 8300 Series Convertible Minitower Maintenance And Service Manual

Hood Sensor

Description
Hood sensor
The hood sensor is located on the top of the rear chassis panel.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Unplug the hood sensor cable from the connector labeled HSENSE on the system board (1).
4. Slide the hood sensor straight out of the slot in the chassis (2).
Figure 6-29
To reinstall the hood sensor, reverse the removal procedure.
104 Chapter 6 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis
Removing the hood sensor
(Preparation for Disassembly on page
(Access Panel on page
Spare part number
638816-001
75).
76).