Antennas - HP Elite 8300 Series Convertible Minitower Maintenance And Service Manual

10. From the inside of the chassis, slide the fan out from underneath the chassis lip, and then
remove the fan.
Figure 9-38
To install the rear fan, reverse the removal procedure.

Antennas

Description
Antenna Hardware Kit
Two antennas are secured to chassis – one on the front, one on the back. You must remove all other
components to remove the antennas.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the optical drive
4. Remove the front fan
5. Remove the hard drive
6. Remove the optical drive rail
7. Remove the heat sink
8. Remove the system board
9. Remove the rear fan
244 Chapter 9 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis
Removing the rear fan
(Removing the Optical Drive on page
(Front Fan on page
(Hard Drive on page
(Optical Drive Rail on page
(Heat sink on page
(System Board on page
(Rear Fan on page
(Preparation for Disassembly on page
(Access Panel on page
218).
222).
227).
231).
241).
243).
Spare part number
646811-001
207).
208).
219).