System Toolbox; User Management; User Code Setup; Adding A User Code - 2gig Technologies Go!Control 2GIG-CNTRL2 User Manual

System Toolbox

User Management

The system installer has pre-programmed a Master User code for your system. This code can be used
to control the system, as well as assign and change the other 31 User Codes and User Code access
options. The Master User Code can also access several system setup settings in the User Toolbox.
The other 31 User Codes are restricted from those settings in the User Toolbox.

User Code Setup

Only the person with the Master User Code can add or change the other User Codes.
To setup the User Codes, use the following steps:
1. On the Home Screen, press SECURITY.
2. On the Security Screen, press MENU.
3. On the Menu Screen, press TOOLBOX.
4. Enter the Master User Code
(the factory setting is 1111).
5. On the Toolbox Screen (1 of 3),
press USER MANAGEMENT.
6. The Users Management Screen displays
three users at a time. Use the ↓ and
↑ arrows to scroll through the list.

Adding a User Code

✓ NOTE: User Codes 0000 and 0001 are
not permitted.
1. Press one of the ADD USER buttons.
2. Enter a four-digit code for the
new User Code and press OK.
3. Enter the Code again to confi rm
the code and press OK.
4. A confi rmation screen will
display, press OK.
5. The User Code's Access Option Screen
will be displayed. The three options
determine when this User Code is valid.
6. Select one of the three options:
ALWAYS; NEVER; or BY SCHEDULE.
• Select ALWAYS to set this User
Code to always be valid. Press BACK.
• Select NEVER to set this User Code
to never be valid. Press BACK.
• Select BY SCHEDULE set this User
Code to be valid only for selected
days and times. See the next section.
28
Toolbox Screen 1
User Management Screen
User Code Entry Screen
User Access Options Screen