Tx Operation - NEC NEFAX655e Manual

TX Operation

TX Operation
Default TX
This function sets the default TX mode of the fax unit. Two options are available:
4 - 27
Choices Available
Memory TX
ADF TX (Direct
Transmission)
Note: In Memory Transmission Mode, you can retrieve your original document
sooner than you can in ADF TX (Direct Transmission) Mode.
1
Press the Program key and scroll through the
menus until you reach the TX Operation Menu.
Press YES to begin programming.
2
Press 1 or scroll down to the Default TX menu and
press YES.
3
Using the Left and Right arrows, select the option
you wish to have as the default, and press YES to
enter this selection into memory.
Description
When the unit is set in this mode, documents are scanned into
memory for transmission and dialing starts after the first page is
scanned (Quick TX).
When the unit is set in this mode, documents are scanned for
transmission after connection has been made to the receiving unit.
(When the available memory is insufficient, select ADF TX for a
successful transmission)
If the Fax line is not available, the message "LINE IS BUSY" will be
displayed. The facsimile will retry to resend based on the number of
redial attempts and intervals that were preset.
TX OPERATION?
YES / or 1-4
1 DEFAULT TX?
OK=YES
*MEM TX ADF TX
-SELECT&PUSH"YES"-
Facsimile Programming