Solid-State Drive Bracket And Connector Board - HP 255 G7 Maintenance And Service Manual

Solid-state drive bracket and connector board

Table 6-6 Spare part description and number
Description
Solid-state drive bracket
Solid-state drive connector board
Solid-state drive cable
Before removing the solid-state drive bracket and connector board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the optical drive (see
3. Remove the bottom cover (see
4. Remove the battery (see
5. Remove the solid-state drive (see
Remove the solid-state drive bracket and connector board:
1. Slide the bracket toward the side of the computer (1), and then lift the bracket out of the computer (2).
2. Disconnect the solid-state connector board cable from the system board ZIF connector (1).
3. Remove the Phillips M2.0 × 3.0 screw (2) that secures the board to the computer.
40 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Preparation for disassembly on page
Optical drive on page
Bottom cover on page
Battery on page 33).
Solid-state drive on page
28).
31).
39).
Spare part number
L20458-001
L22542-001
L20456-001
27).