Solid-State Drive Bracket And Connector Board - HP 17 Maintenance And Service Manual

Solid-state drive bracket and connector board

Description
Solid-state drive bracket
Solid-state drive connector board
Solid-state drive cable
Before removing the solid-state drive bracket and connector board, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the optical drive (see
5. Remove the bottom cover (see
6. Remove the battery (see
7. Remove the solid-state drive (see
Remove the solid-state drive bracket and connector board:
1. Disconnect the cable from the system board ZIF connector (1).
2. Remove the two Phillips M2.0×3.0 screws (2) that secure the board and bracket to the computer.
3. Remove the board from the computer (3).
4. Remove the bracket from the computer (4).
Reverse this procedure to install the solid-state drive bracket and connector board.
46 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Optical drive on page
Bottom cover on page
Battery on page 38).
Solid-state drive on page
32).
36).
45).
Spare part number
L22535-001
L24487-001
L22527-001