Required Information; Hardware Address; Ip Address - Lantronix UDS200 User Manual

Getting Started

Required Information

Hardware Address

Take note of the unit's hardware address (also known as the MAC or Ethernet
address). It is on the product label, in the format: 00-20-4a-XX-XX-XX, where the XXs
are unique numbers assigned to the product (see
11).
Hardware Address: 00-20-4a-_____-_____-_____

IP Address

The UDS must have a unique IP address on your network. This address references
the specific unit. By default, the device is DHCP-enabled and automatically assigned
an IP address on DHCP-enabled networks. If you are assigning a static IP address,
the systems administrator generally provides the IP address, subnet mask, and
gateway.
Note:
and AutoIP. When the units boots, it sends a DHCP broadcast to try and get
an IP address. If it receives no reply from a DHCP server, the UDS tries
BOOTP. If the UDS does not receive a response from BOOTP, it reverts to
an AutoIP address.
IP Address:
Subnet Mask:
Gateway:
You have several options for assigning an IP to your unit. This chapter provides
information about using the DeviceInstaller (graphical user interface) and serial port
login (command line interface) methods.
Note:
as DHCP, AutoIP, ARP and Telnet, see
Address.
The factory default IP address is 0.0.0.0 to enable DHCP, BOOTP,
_______ _______
____ _______
___
_______ _______
For more information other methods of assigning IP addresses, such
Product Information Label
_______ _______
_______ _______
_______ _______
A: Alternative Ways to Assign an IP
13
UDS200 User Guide
on page