Factory Default Settings; Channel 1 And Channel 2 Configuration Defaults; Expert Settings Defaults; Security Settings Defaults - Lantronix UDS200 User Manual

Configuring the UDS Using Telnet or the Serial Port

Factory Default Settings

Select 7 to reset the unit's serial port to the factory default settings. The server
configurations (IP address information) remain unchanged. The specific settings that
this option changes are in the following list:

Channel 1 and Channel 2 Configuration Defaults

Baudrate
I/F Mode
Own TCP port number
Connect Mode
Hostlist retry counter
Hostlist retry timeout
Start character
All other settings

Expert Settings Defaults

TCP keepalive
ARP cache timeout

Security Settings Defaults

SNMP
SNMP community name
Telnet setup
TFTP download
Port 77FEh
Web Server
ECHO
Encryption
Enhanced password

Exiting Configuration Mode

To exit Setup Mode:
To save all changes and reboot, select 9. All values are stored in nonvolatile
memory.
To exit the configuration mode without saving changes or rebooting, select 8.
9600
4C (1 stop bit, no parity, 8 bit, RS-232C)
10001
C0 (always accept incoming connection; no active
connection startup)
3
250 (msec)
0x0D (CR)
0
45 (seconds)
600 (seconds)
Enabled
public
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
36
UDS200 User Guide