Required Information; Hardware Address; Ip Address - Lantronix UDS1100 User Manual

Required Information

Before configuring the UDS, have the following information available:

Hardware Address

Take note of the unit's hardware address (also known as the Ethernet or MAC address).
It is on the product label, in the format: 00-20-4a-XX-XX-XX, where the XXs are unique
numbers assigned to the product (see
Hardware Address: 00-20-4a-_____-_____-_____

IP Address

The UDS must have a unique IP address on your network. This address references the
specific unit. By default, the unit is DHCP-enabled and automatically assigned an IP
address on DHCP-enabled networks. If you are assigning a static IP address, the
systems administrator generally provides the IP address, subnet mask, and gateway.
Note: The factory default IP address is 0.0.0.0 to enable DHCP, BOOTP, and
AutoIP. When the units boots, it sends a DHCP broadcast to try and get an IP
address. If it receives no reply from a DHCP server, the UDS tries BOOTP. If the
UDS does not receive a response from BOOTP, it reverts to an AutoIP address.
IP Address:
Subnet Mask:
Gateway:
You have several options for assigning an IP address and related network settings to
your unit. This chapter provides information about using the DeviceInstaller (graphical
user interface) and serial port login (command line interface) methods.
Note:
For information about other methods of assigning the IP address, such as
DHCP, AutoIP, ARP, and Telnet, see
Address.
UDS1100 User Guide
Product Information
_______ _______ _______
_______ _______ _______
_______ _______ _______
E: Alternative Ways to Assign an IP
3: Installation of UDS1100
Label).
_______
_______
_______
16