Brother MFC-490CW User Manual page 145

Error Message
Unable to Clean XX
Unable to Init. XX
Unable to Print XX
Unable to Scan XX
Unusable Device
Disconnect device from
front connector & turn
machine off & then on
Cause
The machine has a mechanical
problem.
— —
OR
A foreign object such as a clip or
ripped paper is in the machine.
The machine has a mechanical
problem.
— —
OR
A foreign object such as a clip or
ripped paper is in the machine.
The machine has a mechanical
problem.
— —
OR
A foreign object such as a clip or
ripped paper is in the machine.
The machine has a mechanical
problem.
— —
OR
A foreign object such as a clip or
ripped paper is in the machine.
A broken device has been
connected to the USB direct
interface.
Troubleshooting and Routine Maintenance
Action
Open the scanner cover and remove any
foreign objects inside the machine. If the
error message continues, see Transferring
your faxes or Fax Journal report
on page 134 before disconnecting the
machine so you will not lose any important
messages.
Then, disconnect the machine from the
power source for several minutes and then
reconnect it.
Open the scanner cover and remove any
foreign objects inside the machine. If the
error message continues, see Transferring
your faxes or Fax Journal report
on page 134 before disconnecting the
machine so you will not lose any important
messages.
Then, disconnect the machine from the
power source for several minutes and then
reconnect it.
Open the scanner cover and remove any
foreign objects inside the machine. If the
error message continues, see Transferring
your faxes or Fax Journal report
on page 134 before disconnecting the
machine so you will not lose any important
messages.
Then, disconnect the machine from the
power source for several minutes and then
reconnect it.
Open the scanner cover and remove any
foreign objects inside the machine. If the
error message continues, see Transferring
your faxes or Fax Journal report
on page 134 before disconnecting the
machine so you will not lose any important
messages.
Then, disconnect the machine from the
power source for several minutes and then
reconnect it.
Unplug the device from the USB direct
interface, then press Power Save to turn
the machine off and then on again.
B
133