Setting Your Changes As A New Default; Restoring All Settings To The Factory Settings - Brother MFC-490CW User Manual

Using a scanned paper document as
your watermark
a
Press (Copy).
b
Enter the number of copies you want.
c
Press a or b to choose
Watermark Copy.
Press OK.
d
Press d or c to choose On.
e
Press a or b to choose
Current Setting.
Press OK.
f
Press a or b to choose Scan. Press OK,
and place the page that you want to use
as a watermark on the scanner glass.
g
Press Mono Start or Colour Start.
h
Take out the watermark document you
scanned and load the document you
want to copy.
i
Press d or c to change the
Transparency of the watermark.
Press OK.
j
If you do not want to change any
additional settings, press Mono Start or
Colour Start.
Note
You cannot enlarge or reduce the
scanned watermark.
Setting your changes as a
new default
11
You can save the copy settings for Quality,
Enlarge/Reduce, Brightness,
Contrast or Page Layout that you use
most often by setting them as the default
settings. These settings will stay until you
change them again.
a
Press
b
Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
c
After changing the last setting, press
a or b to choose Set New Default.
Press OK.
d
Press 1 to choose Yes.
e
Press Stop/Exit.
Restoring all settings to the
factory settings
You can restore all the settings you have
changed back to the factory settings. These
settings will stay until you change them again.
a
Press
b
Press a or b to choose
Factory Reset.
Press OK.
c
Press 1 to choose Yes.
d
Press Stop/Exit.
Making copies
(Copy).
(Copy).
11
11
11
79