Oce CS120 Reference Manual page 29

I
If the room in which the copier is installed is cold but rapidly heated, water droplets
(condensation) may form inside the copier. This may result in a noticeable degradation in
the quality of the copied image, the inability to properly scan an original, or the copies
having no printed image at all.
I
Electrical interference and vibrations generated by the copier during a Copy job can
adversely affect the operation of such equipment.
I
The copier might interfere with sound and picture signal reception. Plug the copier into a
dedicated power outlet and maintain as much space as possible between the copier and
other electronic equipment.
I
Do not remove the copier's fixing stoppers after the copier has been installed.
If you put weight on the front of the copier when the drawers or units within the copier are
pulled out, the copier may fall forward. To prevent this from happening, make sure that the
copier's fixing stoppers are in place.
About the Installation Location and Handling