3
.
IMPORTANT
•
If the paper is curled, curl it down before placing it into the paper deck.
•
Make sure that the height of the paper stack does not exceed the loading limit ( )
mark.
•
Do not load the following types of paper into the paper deck. Doing so may cause a
paper jam.
- Severely curled or wrinkled paper
- Thin straw paper
- Transparencies
- Paper that has been previously copied onto by this copier (do not copy on the
reverse side either)
- Paper that has been output using a printer or a copier other than this copier (do
not copy on the reverse side either)
•
Always use the stack bypass to feed paper when you copy onto the rear side of a
sheet of paper that already has something copied onto its front side (2nd side of 2-
sided copy).
•
Fan the stack of paper well before loading it.
•
Do not place paper or any other items in the empty part of the paper deck. Doing
so may cause paper jams.
.
NOTE
•
You can load up to 2,500 sheets of paper (20-lb bond (80 g/m
deck.
•
You have to load the paper deck in stages, adding approximately 500 sheets of
paper (20-lb bond (80 g/m
paper, the lifter will descend once again.
•
You can only load LTR-size paper into the paper deck. Paper cannot be loaded
horizontally.
Paper Deck-E1
2
)) each time. If the paper deck can accommodate more
2
)) into the paper