Oce CS120 Reference Manual page 220

.
IMPORTANT
•
The following are the paper sizes that can be stapled: 11" x 17", LGL, LTR, LTRR
•
Stapling is automatically performed only when the originals are fed through the feeder
(option). When using the platen glass to place originals, staple the copies manually after
copying is complete. (See "Manual Stapling Function," on p. 5-40.)
•
You cannot use the Staple-sort function with thin paper (17 to 20-lb bond (64 to 79
2
g/m )), transparencies, Special Paper 1, or Special Paper 2.
.
NOTE
•
If the message <Load staples.> appears on the touch panel display, and the
Staples) indicator lights, you need to load staples into the stapler sorter. After replacing
the staple case, press
manually. (See "Replacing the Staple Case," on p. 5-59.)
•
The maximum number of sets that can be specified is 20. If you enter a number greater
than 20, the number is automatically changed to 20 when you press
•
The maximum number of copies that can be delivered to each of the bins is as follows:
- LTR, LTRR: 30 sheets (20 to 28-lb bond (80 to 104.7 g/m
20 sheets (60-lb cover or 90-lb index to 110-lb index (157 to 209 g/m
- 11" x 17", LGL: 25 sheets (20 to 28-lb bond (80 to 104.7 g/m
15 sheets (60-lb cover or 90-lb index to 110-lb index (157 to 209 g/m
•
If the number of output sheets exceeds the stapling capacity, the copies will be sorted but
not stapled. In this case, manual stapling is also disabled.
•
Once the output exceeds the capacity of the bins, copying will temporarily stop and will
only resume after all the output copies are removed from the bins.
•
When copying onto LTRR-size paper, the output copies may only be sorted but not
stapled depending on the copy exposure. When this happens, the message <Stapling
not possible due to incorrect loading.> will appear on the touch panel display. In this
case, manual stapling is also disabled.
•
Sorting may be interrupted if the copy exposure on the front and rear sides of two-sided
copies is markedly different. If the <Stopped due to incorrect loading. Remove paper
from the sorter.> message is displayed, remove all the output copies from the bins.
Non-sort Mode (Sort, Group, or Staple-sort not specified)
All copies are output to the uppermost non-sort bin.
.
IMPORTANT
•
The maximum capacity of the non-sort bin is approximately 250 sheets (20-lb bond (80
2
g/m )). Exceeding this capacity may cause paper jams. Always remove the output copies
once the maximum capacity is reached.
Manual Stapling Function
(Stapling Start/Stop) lights after copying with the Sort function is complete.
Pressing this key will staple the copies in all the bins.
Stapler Sorter-F2
(Stapling Start/Stop) to continue stapling the remaining copies
(Load
(Start).
2
))
2
))
2
))
2
))