Oce CS120 Reference Manual page 111

•
The physical attributes of paper may change and cause problems in copying due to
environmental factors such as dryness or humidity. To prevent such changes in the
quality of paper, place the transparent sheet that comes with the drawer onto the
bottom of the drawer. Make sure to use the correct-size sheet for the paper you are
loading, and place the sheet such that the arrow on the sheet is against the far-
right corner of the drawer.
•
Do not load the following types of paper into the drawer. Doing so may cause a
paper jam.
- Severely curled or wrinkled paper
- Thin straw paper
- Paper which has been copied onto (do not copy on the reverse side either)
- Paper which has been output using a printer or a copier other than this copier (do
not copy on the reverse side either)
•
Always use the stack bypass to feed paper when you copy onto the rear side of a
sheet of paper that already has something copied onto its front side (2nd side of 2-
sided copy).
•
Fan the stack of paper well before loading it.
•
Do not place paper or any other items in the empty part of the drawer next to the
paper stack. Doing so may cause paper jams.
.
NOTE
•
Each drawer holds about 550 sheets of paper (20-lb bond (80 g/m
•
If there are instructions on the package of paper about which side of the paper to
load, follow those instructions.
•
If problems such as poor copy quality or paper jams occur, try turning the paper
over and loading it.
5
•
2
)).
Loading Paper