Table of Contents
Advertisement
For information on the Chroma property, refer to your application's user manual.
When the Length Control function is selected, the scanner scans the documents in the size that
corresponds to the documents length. If, for instance, Length Control is not selected when A4 and A5 width
documents are scanned continuously, the documents with the A5 width will also be scanned in the A4 size
and the roller will be scanned for the parts corresponding to their bottom halves. Conversely, if Length
Control is selected and A4 documents and A5 width documents are scanned in the same session, the A4
documents will be scanned in the A4 size and the A5 width documents will be scanned in the A5 size, and
no memory is wasted.
Note
The Length Control function has the same functionality as the Auto Length Detection function.
However, setting the Length Control function here overrides the Auto Length Detection function
previously set.
When Detect Paper Width is used, the Size and Page Layout specified in Page Size settings are ignored,
and the scanner sets the page size as determined by the paper guide position.
This function stops scanning when the paper fed by the ADF (Automatic Document Feeder) is significantly
skewed. When Skew Stop has been activated, open the scanner door and remove the paper remaining
inside. Then compare the document against the scanned data, and reinsert the paper up to the appropriate
page. Scanning may not have been completed for some pages of the document remaining inside the
scanner.
Note
The Skew Stop function does not work if the paper width is less than 148 mm.
For information on the Long Paper (X) property, refer to your application's user manual.
2.4.15 Length Control (paper length control)
www.bbhscanners.com
2.4.14 Chroma
2.4.16 Detect Paper Width
2.4.17 Skew Stop
2.4.18 Long Paper (X)
21 of 48
Advertisement
Table of Contents
