Table of Contents
Advertisement
Setting the acoustic signal
In addition to the optical display (e.g. indicating the end of the cycle, errors) you
can also choose to set an acoustic signal.
1. Press the ON/OFF button.
If the name of a stage of a cycle is shown on the display, this means a rinsing cy
cle is active. You must first of all cancel the rinsing cycle:
– Press the RESET key combination.
The display will read CONFIRM CANCEL?
– Press the OK/START button. This will cancel the rinsing cycle.
2. Go to the SOUND VOLUME setting; see the section "Adapting an option/setting".
3. Set the value for the sound volume.
You can set a value from 0 to 5. At 5 the acoustic signals are very loud, at 0 no
acoustic signals are emitted; in addition the symbol
Prior to using for the first time
is lit in the display.
17
Advertisement
Table of Contents
