Table of Contents
Advertisement
Malfunction
1 short warning tone,
continuously repeated, can
be heard,
in the display: OPEN THE
TAP
2 short warning tones,
continuously repeated, can
be heard,
in the display: DRAIN
BLOCKED
(There is water in the dish
washer's internal dispenser)
3 short warning tones,
continuously repeated, can
be heard,
in the display: SERVICE
CODE
1 long warning tone can
be heard,
in the display: SPRAYARM
BLOCKED
In the display: PLEASE
CLOSE DOOR
The cycle is not starting.
Possible cause
Water tap is blocked with
limescale or faulty.
The tap is turned off.
The filter (where present) in the
threaded hose fitting on the tap
is blocked.
Filters in the base of the wash
ing compartment are blocked.
Water inflow hose
has not been correctly posi
tioned.
The sink outlet is blocked.
Water drain hose
has not been correctly posi
tioned.
The anti flood system has been
triggered.
The top basket spray arm is
blocked.
The door of the dishwasher is
open.
The mains plug is not
plugged in.
A fuse in the house's wiring sys
tem is defective.
For dishwasher models with a
delay start timer:
A start time has been selected.
What to do if ...
Remedy
Check the water tap and have it
repaired if necessary.
Turn the tap on.
Clean the filter in the threaded
hose fitting.
Abort the dishwashing cycle (see
section: Starting a dishwashing
cycle);
clean filters (see section: Clean
ing the filters).
Check the position of the hose.
Clean out sink outlet.
Check the position of the hose.
First shut off the water tap, then
switch off the appliance and
contact the Customer Care De
partment.
Open the door carefully .
Hot steam may escape when the
door is opened. There is a risk of
scalding. Arrange the dishes and
cutlery in the baskets so that the
spray arm above can rotate free
ly. Close the dishwasher door.
Close the dishwasher door.
Plug in mains plug.
Replace fuse.
If the dishes are to be washed
immediately, cancel the delay
start.
35
Advertisement
Table of Contents
