Reset - BT SYNERGY 1400 User Manual

To reset your Synergy 1400 base
station to its original settings
Switch off the mains power.
Press and hold down the
Continue to hold down the
button while switching the mains
power back on and for a further five
seconds until the base station gives a
confirmation beep. After another five
seconds a second confirmation beep
will indicate that the base station reset
is complete.
This will reset:
Base station PIN code to 0000.
DIAL DELAY to medium.
MESSAGE ALERT to OFF.
ANS MACHINE to ON.
TIME & DAY setting to SAT 1 2 : 0 1.
RECALL MODE to TB.
RINGER VOLUME to high.
RINGER MELODY to A.
It will remove:
All handsets registered to the base
station. All shared numbers stored in
the memory. Clear all messages left or
recorded.
To reset your Synergy 1400 handset
to its original settings
button.
PAGE
PAGE
Press the button several times until
display shows SET UP.
Press the button. Display shows
HANDSET.
button. Display shows LEVEL.
Press the
Press the button several times until
the display shows RESET.
Press the button. Display shows
CONFIRM.
Press the button. Display shows
CONFIRM again.
button. Display shows REG.
Press the
The handset is reset, and is now
de-registered from the base station(s).
This will reset:
RINGER VOLUME to high.
RINGER MELODY to A.
EARPIECE VOLUME (III).
KEYTONES to ON.
QUICKDIAL MEMORY to shared.
It will delete
Quickdial numbers stored in the
personal memory.
Last number redial memory.
Personal emergency numbers.
Unchanged:
Quickdial numbers stored in the shared
memory.
You will now need to re-register your
handset. Follow the instructions on
page 46.
37