Using Additional Handsets - BT SYNERGY 1400 User Manual

Using additional handsets

Registering an additional
Synergy handset with
the base station or
re-registering a handset
Up to six handsets can be registered and
operated from the Synergy 1400 base station.
The system allows intercom calls between two
handsets while a third is making an external call.
Each additional handset you purchase must be
registered with the base station.
PLEASE NOTE
Remember to charge the batteries for at least
16 hours. When switched on, the additional
handset will display REG. This tells you that the
handset is not registered with the base station.
To register a handset
Press buttons in order shown
At the base station:
Press and hold down the blue
button until you hear a beep (after
about 10 seconds).
46
You now have up to 1 minute to register
the handset, during which the beeps will
continue and the IN-USE light flashes
on the base station.
At the handset:
Press the
the display shows SET UP.
Press the
HANDSET.
Press the
Press the
the display shows REG.
Press the
Press the
PLS WAIT then, after a short delay, the
Park No. of the base station is displayed.
Press the
PIN - - ----- .
Enter the four-digit base station code.
(Default 0000. Enter this if the base
station code has not been changed.)
The ---- marks disappear one by one.
PAGE Press the
confirmation beep. Display shows
LABEL - - (which refers to the handset
number).
button several times until
button. Display shows
button. Display shows LEVEL.
button several times until
button. Display shows ADD.
button. Display shows
button. Display shows
button. You hear a