Setting Up - BT SYNERGY 1400 User Manual

Setting up

Follow these steps to get your Synergy 1400 ready for use.
To plan location of the base
1
station
Your Synergy 1400 works by sending and
receiving radio signals between the base station
and the handset.
The strength of the signal depends on where
you site the base station. The higher the base
station is located, the better. An upstairs room is
ideal. The following points should be considered:
•
It should be within 2 metres of a power
socket and phone socket otherwise
extension cables will be required.
•
Try to avoid locations near metallic obstructions
or electrical appliances, such as TV sets,
fridges, computers, fluorescent lights, radiators,
metal pipes and metal window frames.
2 Connect the power cable
Plug the power cable into the power socket on
the underside of your Synergy 1400. When the
power is switched on, the answering machine
will announce the day and time setting, followed
by the outgoing message announcement.
Install the rechargeable batter y in
3
the handset
The Synergy 1400 handset uses a nickel cadmium
(NiCad) battery pack supplied. Hold the handset
with the keypad facing down, remove the clear
plastic directory label cover and memo card and
press and slide open the battery compartment.
Insert the battery pack inside the battery
compartment and slide the battery
compartment cover shut. Replace the memo
card and the directory label cover.
Push
7