Performance - GE MDS SD Series Technical Manual

Radio Performance
MDS 05-4846A01, Rev. H
•
Alarm Signal Sense
or . An active high means that Pin 6 on the
Active Low
will output a high DC signal when an alarm exists. (This is the
default behavior.) An active low means that Pin 6 on the
port will output a low DC signal when an alarm exists. Select the
desired behavior in the drop-down box and click
to apply the setting.
Sense
•
Set Signal by Class
result in an signal being produced by the alarm output line. The
choices are:
Never assert Alarm Signal
Assert Signal on Major Alarm
Assert Signal on Major or Minor Alarm
Assert Signal on Any Alarm or Status
• —This button is used to set the selections made in the
Set Alarm Bits
check box list below it. First, you must select which specific
alarms will result in a signal being produced by the alarm output
line. To set an alarm/message for reporting by the output line, you
click the check box next to an item of interest. To clear a check
box, simply click it again. When you are finished with the selec-
tions, click the
• —This button is used to return the screen to its original selec-
Undo
tions. It clears any selections made prior to clicking the
button.
Bits

Performance

This screen contains several measurement parameters that can be used
to check the operating conditions of the radio.
•
Measured RF Power
put power (in dBm).
• —Read-only indication of the signal-to-noise ratio of
Signal to Noise
received signal.
• —Read-only indication of the received signal strength (in
RSSI
dBm).
• —Read-only indication of the DC supply voltage
DC Voltage
applied to the transceiver.
• —Read-only indication of the chassis temperature
Temperature
(degrees C).
SD Series Technical Manual
—This parameter may be set to either
—Here, you can specify what classes of alarms
button.
Set Alarm Bits
—Read-only indication of the measured RF out-
Active High
port
COM2
COM2
Set Alarm Signal
Set Alarm
75