GE MDS SD Series Technical Manual page 91

Verify Image
Copy Image
MDS 05-4846A01, Rev. H
• —Set to either intrusive or passive as desired.
Channel Usage
• —Used to specify the size of the reprogramming
Packet Data Size
data packets. Default size is
• —Used to specify the number of times a transmission
Retry Count
is repeated when a packet is not received correctly. Default set-
ting is .
3
•
Reprogram Block Size
data packet. Default setting is
• —When enabled, causes the transceiver to automati-
Auto-Reboot
cally reboot after a firmware image upgrade. If disabled, the
newly loaded image will not become valid until the transceiver is
rebooted manually.
• —This field can be used to introduce a time delay
Download Delay
when reprogramming begins. Typically, it is set to
but may be increased incrementally by selecting one of the
extended delay times from the drop-down box (
)
3, None
This screen is used to verify the integrity of an image stored in flash
memory. You may wish to verify an image after reprogramming or as
part of a troubleshooting sequence.
• —Click this button to verify the firmware image selected in
Verify
the drop-down box at the top of the screen. The available selec-
tions from the box are:
.
tive image
SD Series Technical Manual
.
40
—Sets the overall block size (in bytes) of each
.
512
Current active image
Extended Delay-1
Extended Delay-1, 2,
, , , and
Image 1 Image 2 Inac-
,
83