GE MDS SD Series Technical Manual page 55

MDS 05-4846A01, Rev. H
port is what actually puts the radio to sleep. This signal
COM2
must be supplied by the equipment connected to the radio (i.e.,
RTU, PLC, etc.). Sleep mode is not intended for use on Master
radios.
• —The behavior of the radio's
COM LED Mode
may be configured using this box. By default, the LEDs show
dual port activity (
summarized in Table 13.
Table 13. COM/DATA LED Modes vs. Behavior
LED Mode Selection
x710 Monitors TXD on COM2
port
COM1 Activity Monitors any COM1 RX or
TX activity
COM2 Activity OFF
Dual Port Activity Monitors any COM1 RX or
(Auto Default) TX activity
• —The radio can operate in one of several modes. The
Radio Mode
available selections are:
• Packet - with and without AES Encryption
• Packet w/MAC - with and without AES Encryption
• x710 (not covered by this manual; See pub. 05-4670A01)
• Transparent - with and without AES Encryption. (Transpar-
ent w/AES Encryption requires an all SD radio network.)
• —This parameter selects the method of radio manage-
User Interface
ment for the Serial/Telnet interface. It has no effect on the web
interface. The default selection is
select , which switches the radio to a Command Line Interface.
CLI
With this interface, commands are entered in text-based fashion,
as described in the SD Serial/Telnet Management Supplement,
Part No. 05-6193A01.
SD Series Technical Manual
). Four LED modes may be selected as
Auto
Serial COM/DATA LED Behavior
LED1 Function
. Alternatively, you may
Menu
LEDs
COM/DATA
LED2 Function
Monitors RXD on COM2
port
OFF
Monitors any COM2 RX or
TX activity
Monitors any COM2 RX or
TX activity
47