Communications Ports - GE MDS SD Series Technical Manual

Peer-to-Peer
(Peer2Peer)
COM1 Port Settings
MDS 05-4846A01, Rev. H
•
Rebroadcast Allowed (AP only)
enabled Peers to communicate through the AP to other enabled
Peers (serial data only).
•
Ethernet Rebcast Allowed (AP only)
enabled Peers to communicate through the AP to other enabled
Peers (Ethernet data only).
•
Serial Rebcast Request (RM only)
allowed to communicate to other enabled Peers.
•
Ethernet Rebcast Request (RM only)
allowed to communicate to other enabled Peers.

Communications Ports

• —The default mode for
Startup Mode
transceiver is first powered up, but the startup mode may also be
set to if the port is to be used for passing payload data.
Data
• —The mode setting for the
Current Mode
changed on demand (
• —The default data rate for
Data Baud Rate
it may be set to any of the following speeds: 300, 1200, 2400,
4800, 9600, 19200, 38400, 57600, 115200.
SD Series Technical Manual
— Determines if the AP will allow
—Determines if the AP will allow
— Determines if the Remote is
—Determines if the Remote is
is
COM1
COM1
or ) using this selection.
Console Data
COM1
when the
Console
port may be
is 115200 bps, but
67