GE MDS SD Series Technical Manual page 60

Diagnostic Settings
52
• —This parameter identifies the radio in the wireless network
Unit #
with a specific ID during diagnostic sessions. This value is
defaulted to the last 4-digits of the unit's Serial Number. Should
a network require a Unit # change, the value must be greater than
10000 in decimal (2710 in hexadecimal).
• —This setting identifies the radio as either a Node, Root,
Dlink Type
Repeater, Peer, or Gate. Each of these are operating modes of the
transceiver with respect to diagnostic/management activities.
(See "Performing Network-Wide Remote Diagnostics" on
Page 93 for details.)
• —This item is used to enable or disable diagnostics
Dlink Status
functionality. Setting it to
diagnostic link protocol (DLINK) over the radio's
ment port.
• —This setting determines the COM1 serial data
Dlink Baud Rate
diagnostics communication rate in bits-per-second (bps).
• —This setting enables DLINK over Ethernet via
Dlink TCP Access
TCP. This allows an external NMS to manage the radio without
the need to dedicate a serial port for this function.
• —This setting specifies the TCP port for DLINK
Dlink TCP Port
communication. The address for Ethernet-based DLINK commu-
nication is given by the radio's IP address (from the
screen) and the port number specified here.
SD Series Technical Manual
configures the radio to pass the
ON
MDS 05-4846A01, Rev. H
manage-
COM1
Overview