GE MDS SD Series Technical Manual page 122

LED status indicator (PWR LED) 33
RF, chart for converting dBm-Watts-Volts 108
specifications 102
Procedures
checking for alarms (STAT command) 89
downloading new software 94
mounting the transceiver 19
network-wide diagnostics 93, 99, 102
troubleshooting 87–91
Product
description 3, 4
model number codes 8
Protected Network Station
definition of 8
PWR
LED 33
R
Radio
Configuration Software 94
inoperative (troubleshooting chart) 87
no synchronization with master (troubleshooting
chart) 88
poor performance (troubleshooting chart) 88
Receiver
specifications 102
system specifications 101
Redundant operation, defined 107
Remote
Station, defined 107
Station, illustrated 18
RTU (Remote Terminal Unit)
defined 107
S
SCADA (Supervisory Control And Data Acquisition),
defined 107
Signal
loss due to coaxial cable length at 960 MHz, table 22
Simplex 12
Sleep mode
shown by PWR LED status indicator 33
Software
diagnostics and control used from PC 94
upgrading 94
Specifications
diagnostics interface 102
environment 102
power 102
receiver 102
receiver system 101
transmitter 101
transmitter system 101
Standing Wave Ratio—See SWR. 107
Supervisory Control And Data Acquisition—See
SCADA. 108
SWR (Standing Wave Radio), defined 108
T
Tables
alarm code definitions 90
conversions, dBm-Watts-Volts 108
LED status indicators 33
length vs. loss in coaxial cables at 960 MHz 22
troubleshooting 87
I-2
Technical reference 91–103
Transceiver
diagnostics using PC software 94
mounting 28
mounting instructions 19
upgrading software 94
Transmitter
specifications 101
system specifications 101
Troubleshooting 87–91
performing network-wide diagnostics 93, 99, 102
STAT command (Status) 89
table 87
using PC software for 94
SD Series Technical Manual MDS 05-4846A01, Rev. H