Features - GE MDS SD Series Technical Manual

Secure, long range ip/ethernet & serial
Hide thumbs Also See for MDS SD Series:
Table of Contents

Advertisement

Bridge
Configuration
VLAN Configuration
MDS 05-4846A01, Rev. H

Features

—Used to enable or disable Ethernet Bridging on the
Bridge Mode
radio. Default setting is
Basic Bridge Filter Sel
Available selections are:
.
Unicast Only
Adv Bridge Filter Status
traffic received from a specific Ethernet-enabled device matching
one of the Adv Src Addr Filter Values (see below).
Adv Src Addr Filter 1-4 Val
Values. Four address fields are available. If the Adv Bridge Filter
Status is on, and an incoming Ethernet frame src addr matches
any of these values, the radio bridges the frame. Otherwise, it is
dropped by the radio. The entry format must be
Ageout Time (mins)
radio holds a specific MAC entry in the Bridge route table. The
parameter can be varied from 0 to 5 minutes. Default for this set-
ting is
minutes.
5
— When set as SMART, this filter prevents any packets
Lan filter
which were transmitted from one endpoint to another which are
connected through a hub on a single transceiver. Default is
NOTE: This feature should be disabled if there is a redundant bridge
in the network.
A VLAN is essentially a limited broadcast domain, meaning that all
members of a VLAN receive broadcast frames sent by members of the
same VLAN but not frames sent by members of a different VLAN.
The radio supports port-based VLAN at the Ethernet interface and over
the air, according to the IEEE 802.1Q standard. When VLAN Mode is
enabled, the wireless port of both AP and Remote radios act as a Trunk
port.
The Ethernet port of an AP radio is normally configured as a trunk port.
This type of port expects incoming frames to have a VLAN ID and sends
outgoing frames with a VLAN structure as well. The Ethernet port of a
Remote radio can be configured as an Access port or as a Trunk port.
SD Series Technical Manual
.
OFF
—Sets the type of bridge filter to be used.
Broadcast/Unicast (All), Unicast and ARP,
—When on, this filter bridges the Ethernet
—Sets the Advanced SRC Address Filter
— Defines the amount of time (in minutes) a
and
.
xx:xx:xx:xx:xx:xx
.
AUTO
55

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents