Web Browser Connection - GE MDS SD Series Technical Manual

Requirements
Logging On
30

Web Browser Connection

This section describes connection and use of the radio's built-in Device
Manager. To connect to the radio and manage it via the Device Man-
ager, you will need the following:
• A PC with a web browser program installed.
• An Ethernet cable connected between the PC and the radio as
shown in Figure 22. (Alternatively, a network connection may be
used, as long as the radio can be reached via its IP address.)
• The radio's IP address. Check with your Network Administrator,
or determine the address via a serial/console connection (see
ing Information Screen
radio is
192.168.1.1
• The user name and password for the radio. Check with your Net-
work Administrator, or, if a username and password have not
been set, use the factory defaults of
security, a new password should be established as soon as possi-
ble after login.)
Figure 22. PC Connection to Radio for Web Management
1. Connect the radio to a PC via an Ethernet connection.
2. Configure your PC network settings to an IP address on the same
subnet as the radio. The default subnet mask is
3. Enter the radio's IP address in a web browser window, just as you
would enter a website address (http://192.168.1.1). When the login
screen appears (Figure 23), enter the User Name and Password for
the radio. The default entries for a new radio are both
.
OK
SD Series Technical Manual
). The default address for a factory supplied
.
admin
Invisible place holder
Start-
for both entries. (For
.
255.255.0.0
. Click
admin
MDS 05-4846A01, Rev. H