Ethernet Wan; Cellular Wan - ZyXEL Communications LTE Series User Manual

Table 15 Network Setting > Broadband > Add/Edit New WAN Interface (Routing Mode)
LABEL
Primary DNS
Server
Secondary DNS
Server
IPv6 Routing Feature
MLD Proxy
Enable
Apply as Default
Gateway
Cancel
Apply

5.3 Ethernet WAN

Use this screen to have the forth LAN port act as an Ethernet WAN port. You can restore it back from a
WAN port to a LAN port. Click the switch to set up the configuration. When the switch goes to the right,
the forth LAN port act as an Ethernet WAN port. Otherwise, the forth LAN port remains as a LAN port.
Click Apply to save your changes back to the Zyxel Device.
Click Network Setting > Broadband > Ethernet WAN to display the following screen.
Figure 35 Network Setting > Broadband > Ethernet WAN

5.4 Cellular WAN

Click Network Setting > Broadband > Cellular WAN to display the following screen. Configure an LTE
connection, including the Access Point Name (APN) provided by your service provider.
Chapter 5 Broadband
DESCRIPTION
Enter the first IPv6 DNS server address assigned by the ISP.
Enter the second IPv6 DNS server address assigned by the ISP.
Select this check box to have the Zyxel Device act as an MLD proxy on this connection. This
allows the Zyxel Device to get subscription information and maintain a joined member list for
each multicast group. It can reduce multicast traffic significantly.
Select this option to have the Zyxel Device use the WAN interface of this connection as the
system default gateway.
Click Cancel to exit this screen without saving.
Click Apply to save your changes.
LTE Series User's Guide
54